Dedicated to promotion of uniform enforcement and development of the codes throughout the State to assure health, safety, and welfare of its citizens.
2021 Workshops
The Officers and Directors of the North Carolina Mechanical Inspectors Association are pleased to announce that workshops will be conducted this year to address the topics listed below.
Attendance at any one of these workshops will provide six hours of continuing education credit for the North Carolina Mechanical Code Inspector certificate as required by the North Carolina Code Officials Qualification Board.
A six-hour workshop highlighting and explaining Mechanical Code Provisions will be provided through Webinars.
February 3rd and 17th classes are as follows
Gas Appliance Venting
Energy Code
Interpretations and Installation Issues
March 17th, April 14th, May 12th Classes are as follows.
Chapter 4 Ventilation Mechanical code
Chapter 5 Exhaust Mechanical code
Chapter 4 Fuel Gas Code, Fuel gas piping
August 18th, 2021 class
SMACNA Training on NEW 2021 Manual for Commercial Duct construction
SMACNA DCS-101 Duct Basics
SMACNA DCS-102 Rectangular internal supports and large duct
SMACNA DCS-103 Round and Oval construction plus hangers
SMACNA-Ducts for non-HVAC applications
8:00 AM - 3:00 PM | Workshops (1-hr lunch break)
You must have a device with a camera and microphone to attend, and you have to have the camera on and you in the image. If you are not, then you will not get credit for the class.